Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 682)

100

101

Management Commands

682

ProSafe M4100 and M7100 Managed Switches

no radius server attribute

Use the

no version of this command to disable the NAS-IP-Address attribute global

parameter for RADIUS client. When this parameter is disabled, the RADIUS client does not

send the NAS-IP-Address attribute in RADIUS requests.

Format no radius server attribute <4> [<ipaddr>]

Mode

The following shows an example of the command.

(Switch) (Config) #radius server attribute 4 192.168.37.60

(Switch) (Config) #radius server attribute 4

radius server host

Use this command to configure the IP address or DNS name to use for communicating with

the RADIUS server of a selected server type. While configuring the IP address or DNS name

for the authenticating or accounting servers, you can also configure the port number and

server name. If the authenticating and accounting servers are configured without a name, the

command uses the ‘Default_RADIUS_Auth_Server’ and ‘Default_RADIUS_Acct_Server’ as

the default names, respectively. The same name can be configured for more than one

authenticating servers and the name should be unique for accounting servers. The RADIUS

client allows the configuration of a maximum 32 authenticating and accounting servers.

If you use the <auth> parameter

, the command configures the IP address or hostname to

use to connect to a RADIUS authentication server. You can configure up to 3 servers per

RADIUS client. If the maximum number of configured servers is reached, the command fails

until you remove one of the servers by issuing the “no” form of the command. If you use the

optional <port> parameter, the command configures the UDP port number to use when

connecting to the configured RADIUS server. The <port> number range is 1 - 65535, with

1812 being the default value.

Note: To reconfigure a RADIUS authentication server to use the default

UDP <port>, set the <port> parameter to 1812.

If you use the <acct> token, the command configures the IP address or hostname to use for

the RADIUS accounting server

. You can only configure one accounting server. If an

accounting server is currently configured, use the “no” form of the command to remove it from

the configuration. The IP address or hostname you specify must match that of a previously

configured accounting server. If you use the optional <port> parameter, the command

configures the UDP port to use when connecting to the RADIUS accounting server. If a

<port> is already configured for the accounting server, the new <port> replaces the

previously configured <port>. The <port> must be a value in the range 0 - 65535, with

1813 being the default.

Global Config

1 2 ... 677 678 679 680 681 682 683 684 685 686 687 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 682

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+