Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 598)

100

101

Utility Commands

598

ProSafe M4100 and M7100 Managed Switches

The following parameters are displayed in the trace message:

TX/RX

Intf

SRC_IP

DEST_IP

Type

no debug ping packet

This command disables tracing of ICMP echo requests and responses.

Format no debug ping packet

Mode

debug rip packet

This command turns on tracing of RIP requests and responses. This command takes no

options. The output is directed to the log file.

Default

Format debug rip packet

Mode

A sample output of the trace message is shown below.

<15> JAN 01 00:35:15 192.168.17.29-1 RIP[181783160]: rip_map_debug.c(96) 775 %

Pkt RX on Intf: 0/1(1), Src_IP:43.1.1.1 Dest_IP:43.1.1.2

Rip_Version: RIPv2 Packet_Type:RIP_RESPONSE

ROUTE 1): Network: 10.1.1.0 Mask: 255.255.255.0 Metric: 1

ROUTE 2): Network: 40.1.0.0 Mask: 255.255.0.0 Metric: 1

ROUTE 3): Network: 10.50.50.0 Mask: 255.255.255.0 Metric: 1

ROUTE 4): Network: 41.1.0.0 Mask: 255.255.0.0 Metric: 1

ROUTE 5): Network:42.0.0.0 Mask:255.0.0.0 Metric:1

Another 6 routes present in packet not displayed.

Parameter Definition

TX refers to a packet transmitted by the device. RX refers to packets received by the

device.

The interface that the packet came in or went out on. Format used is slot/port (internal

interface number). Unit is always shown as 1 for interfaces on a non-stacking device.

The source IP address in the IP header in the packet.

The destination IP address in the IP header in the packet.

Type determines whether or not the ICMP message is a REQUEST or a RESPONSE.

Privileged EXEC

disabled

Privileged EXEC

1 2 ... 593 594 595 596 597 598 599 600 601 602 603 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 598

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+