Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 631)

100

101

Management Commands

631

ProSafe M4100 and M7100 Managed Switches

enable authentication

Use this command in line configuration mode to specify an authentication method list when

the user accesses a higher privilege level in remote telnet or console.

Format enable authentication {default | list-name}

Mode

no enable authentication

Use this command to return to the default specified by the

enable authentication

command.

Format no enable authentication {default | list-name}

Mode

show serial

Use this command to display serial communication settings for the switch.

Format show serial

Modes

• Privileged EXEC

• User EXEC

Serial Port

(minutes)

Baud Rate (bps)

Character Size

(bits)

Flow Control

Stop Bits

Parity Type

Telnet Commands

This section describes the commands you use to configure and view Telnet settings. You can

use Telnet to manage the device from a remote management host.

Line Config

Term Definition

The time, in minutes, of inactivity on a Serial port connection, after which the Switch will

close the connection. Any numeric value from 0 through 160 is allowed, the factory

default is 5. A value of 0 disables the timeout.

The default baud rate at which the serial port will try to connect. The available values are

1200, 2400, 4800, 9600, 19200, 38400,57600, and 1

15,200 baud. The factory default is

9600 baud.

The number of bits in a character. The number of bits is always 8.

Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is

always disabled.

The number of Stop bits per character. The number of Stop bits is always 1.

The parity method used on the serial port. The parity method is always None.

1 2 ... 626 627 628 629 630 631 632 633 634 635 636 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 631

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+