Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 730)

100

101

Log Messages

730

ProSafe M4100 and M7100 Managed Switches

Technologies

Table 54. System General Error Messages

Component Message Cause

Invalid USP unit = x, slot = x, port =x A port was not able to be translated

correctly during the receive.

In hapiBroadSystemMacAddress call to

'bcm_l2_addr_add' - FAILED : x

Failed to add an L2 address to the MAC

table. This should only happen when a

hash collision occurs or the table is full.

Failed installing mirror action - rest of the

policy applied successfully

A previously configured probe port is not

being used in the policy. The release notes

state that only a single probe port can be

configured

Policy x does not contain rule x The rule was not added to the policy due to

a discrepancy in the rule count for this

specific policy . Additionally, the message

can be displayed when an old rule is being

modified, but the old rule is not in the policy

ERROR: policy x, tmpPolicy x, size x, data

x x x x x x x x

An issue installing the policy due to a

possible duplicate hash

ACL x not found in internal table Attempting to delete a non-existent ACL

ACL internal table overflow Attempting to add an ACL to a full table

In hapiBroadQosCosQueueConfig, Failed

to configure minimum bandwidth. Available

bandwidth x

Attempting to configure the bandwidth

beyond its capabilities

USL: failed to put sync response on queue A response to a sync request was not

enqueued. This could indicate that a

previous sync request was received after it

was timed out

USL: failed to sync ipmc table on unit=x Either the transport failed or the message

was dropped

usl_task_ipmc_msg_send(): failed to send

with x

Either the transport failed or the message

was dropped

USL: No available entries in the STG table The Spanning Tree Group table is full in

USL

USL: failed to sync stg table on unit=x Could not synchronize unit x due to a

transport failure or API issue on remote

unit. A synchronization retry will be issued

USL: A Trunk doesn't exist in USL Attempting to modify a Trunk that doesn’t

exist

1 2 ... 725 726 727 728 729 730 731 732 733 734 735 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 730

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+