Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 604)

100

101

Utility Commands

604

ProSafe M4100 and M7100 Managed Switches

cablestatus

This command returns the status of the specified port.

Format cablestatus <slot/port>

Mode

sFlow Commands

sFlow

is the standard for monitoring high-speed switched and routed networks. sFlow

technology is built into network equipment and gives complete visibility into network activity,

enabling effective management and control of network resources.

sflow receiver

Use this command to configure the sFlow collector parameters (owner string, receiver

timeout, max datagram size, IP address, and port).

Format sflow receiver <rcvr_idx> owner <owner-string> [timeout

<rcvr_timeout> | notimeout] max datagram <size> ip/ipv6 <ip> port

<port>

Mode

Privileged EXEC

Field Description

Cable Status

One of the following statuses is returned:

• Normal: The cable is working correctly.

• Open: The cable is disconnected or there is a faulty connector.

• Short: There is an electrical short in the cable.

• Cable Test Failed: The cable status could not be determined. The cable may in fact

be working.

Cable Length

If this feature is supported by the PHY for the current link speed, the cable length is

displayed as a range between the shortest estimated length and the longest estimated

length. Note that if the link is down and a cable is attached to a 10/100 Ethernet adapter,

then the cable status may display as Open or Short because some Ethernet adapters

leave unused wire pairs unterminated or grounded. Unknown is displayed if the cable

length could not be determined.

Global Config

1 2 ... 599 600 601 602 603 604 605 606 607 608 609 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 604

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+