Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 479)

100

101

Quality of Service (QoS) Commands

479

ProSafe M4100 and M7100 Managed Switches

no access-list

This command deletes an IP ACL that is identified by the parameter <accesslistnumber>

from the system.

The range for <accesslistnumber> 1-99 for standard access lists and

100-199 for extended access lists.

Format no access-list <accesslistnumber>

Mode

ip access-list

This command creates an extended IP access control list (ACL) identified by <name>,

consisting of classification fields defined for the IP header of an IPv4 frame. The <name>

parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely

identifying the IP access list.

{icmp | igmp | ip | tcp | udp

| <number>}

Specifies the protocol to filter for an extended IP ACL rule.

Specifies a source IP address and source netmask for match

condition of the IP

ACL rule.

[{eq {<portkey> |

<0-65535>}]

Specifies the source layer 4-port match condition for the IP ACL rule.

ou can use the port number, which ranges from 0-65,535, or you

specify the <portkey>, which can be one of the following

keywords: domain, echo, ftp, ftpdata, http, smtp,

snmp, telnet, tftp, and www-http. Each of these keywords

translates into its equivalent port number, which is used as both the

start and end of a port range.

Specifies a destination IP address and netmask for match condition

of the IP

ACL rule.

[precedence <precedence> |

tos <tos> <tosmask> | dscp

<dscp>]

Specifies the TOS for an IP ACL rule depending on a match of

precedence or DSCP values using the parameters dscp,

precedence, tos/tosmask.

[log]

Specifies that this rule is to be logged.

rate-limit

The user can specify a simple rate limiter for packets matching an

ACL “permit” rule.

The user needs to specify the burst size in kbytes

and allowed rate of traffic in kbps. The conforming traffic is allowed

to transmit, and non-conforming traffic is dropped. This action is

ignored for any “deny” rule, since by definition matching packets are

dropped.

[assign-queue <queue-id>]

Specifies the assign-queue, which is the queue identifier to which

packets matching this rule are assigned.

[{mirror | redirect}

<slot/port>]

Specifies the mirror or redirect interface which is the slot/port to

which packets matching this rule are copied or forwarded,

respectively

Global Config

Parameter Description

1 2 ... 474 475 476 477 478 479 480 481 482 483 484 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 479

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+