Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 531)

100

101

Utility Commands

531

ProSafe M4100 and M7100 Managed Switches

Note: If you issue the show running-config command from a serial

connection, access to the switch through remote connections (such

as Telnet) is suspended while the output is being generated and

displayed.

Note: If you use a text-based configuration file, the show

running-config command will only display configured physical

interfaces, that is, if any interface only contains the default

configuration, that interface will be skipped from the show

running-config command output. This is true for any

configuration mode that contains nothing but default configuration.

That is, the command to enter a particular config mode, followed

immediately by its ‘exit’ command, are both omitted from the show

running-config command output (and hence from the

startup-config file when the system configuration is saved.)

If all the flags in a particular group are enabled, the command displays trapflags <group

name> all.

If some, but not all, of the flags in that group are enabled, the command displays trapflags

<groupname> <flag-name>.

Format show running-config [all | <scriptname>]

Mode

show running-config interface

This command shows the current configuration on a particular interface. The interface could

be a physical port or a virtual port—like a LAG or VLAN. The output captures how the

configuration differs from the factory default value.

Format

Mode

show sysinfo

This command displays switch information.

Format show sysinfo

Mode

Privileged EXEC

show running-config interface {<slot/port>} | VLAN <id> | LAG <id>}

Interface Config

Privileged EXEC

1 2 ... 526 527 528 529 530 531 532 533 534 535 536 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 531

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+