Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 382)

100

101

IPv6 Commands

382

ProSafe M4100 and M7100 Managed Switches

no ipv6 ospf hello-interval

This command sets the default OSPF hello interval for the specified interface.

Format no ipv6 ospf hello-interval

Mode

ipv6 ospf mtu-ignore

This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF

Database Description packets specify the size of the largest IP packet that can be sent

without fragmentation on the interface. When a router receives a Database Description

packet, it examines the MTU advertised by the neighbor. By default, if the MTU is larger than

the router can accept, the Database Description packet is rejected and the OSPF adjacency

is not established.

Default

Format ipv6 ospf mtu-ignore

Mode

no ipv6 ospf mtu-ignore

This command enables the OSPF MTU mismatch detection.

Format no ipv6 ospf mtu-ignore

Mode

ipv6 ospf network

This command changes the default OSPF network type for the interface. Normally, the

network type is determined from the physical IP network type. By default all Ethernet

networks are OSPF type broadcast. Similarly, tunnel interfaces default to point-to-point.

When an Ethernet port is used as a single large bandwidth IP network between two routers,

the network type can be point-to-point since there are only two routers. Using point-to-point

as the network type eliminates the overhead of the OSPF designated router election. It is

normally not useful to set a tunnel to OSPF network type broadcast.

Default

Format ipv6 ospf network {broadcast | point-to-point}

Mode

Format ipv6 ospf hello-interval <seconds>

Mode

Interface Config

enabled

Interface Config

broadcast

Interface Config

1 2 ... 377 378 379 380 381 382 383 384 385 386 387 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 382

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+