Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 675)

100

101

Management Commands

675

ProSafe M4100 and M7100 Managed Switches

no snmp-server enable traps multiusers

Use this command to disable Multiple User traps.

Format no snmp-server enable traps multiusers

Mode

snmp-server enable traps stpmode

Use this command to enable sending new root traps and topology change notification traps.

Default

Format snmp-server enable traps stpmode

Mode

no snmp-server enable traps stpmode

Use this command to disable sending new root traps and topology change notification traps.

Format no snmp-server enable traps stpmode

Mode

snmptrap

Use this command to add an SNMP trap receiver. The maximum length of <name> is 16

case-sensitive alphanumeric characters. The <snmpversion> is the version of SNMP. The

version parameter options are snmpv1 or snmpv2. The SNMP trap address can be set using

both an IPv4 address format as well as an IPv6 global address format.

The following shows an example of the CLI command.

(Netgear Switch)# snmptrap mytrap ip6addr 3099::2

Note: The <name> parameter does not need to be unique, however; the

<name> and <ipaddr | hostname> pair must be unique. Multiple

entries can exist with the same <name>, as long as they are

associated with a different <ipaddr | hostname>. The reverse

scenario is also acceptable. The <name> is the community name

used when sending the trap to the receiver, but the <name> is not

directly associated with the SNMP Community Table, See

“snmp-server community” on page39.”

Global Config

enabled

Global Config

1 2 ... 670 671 672 673 674 675 676 677 678 679 680 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 675

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+