Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 232)

100

101

Routing Commands

232

ProSafe M4100 and M7100 Managed Switches

ip route default

This command configures the default route. The value for <nexthopip> is a valid IP

address of the next hop router. The <preference> is an integer value from 1 to 255. A route

with a preference of 255 cannot be used to forward traffic.

Default

Format ip route default <nexthopip> [<preference>]

Mode

no ip route default

This command deletes all configured default routes. If the optional <nexthopip> parameter

is designated, the specific next hop is deleted from the configured default route and if the

optional preference value is designated, the preference of the configured default route is

reset to its default.

Format no ip route default [{<nexthopip> | <preference>}]

Mode

ip route distance

This command sets the default distance (preference) for static routes. Lower route distance

values are preferred when determining the best route. The ip route and ip route

default commands allow you to optionally set the distance (preference) of an individual

static route. The default distance is used when no distance is specified in these commands.

Changing the default distance does not update the distance of existing static routes, even if

they were assigned the original default distance. The new default distance will only be

applied to static routes created after invoking the ip route distance command.

Default

Format ip route distance <1-255>

Mode

no ip route distance

This command sets the default static route preference value in the router. Lower route

preference values are preferred when determining the best route.

Format no ip route distance

Mode

preference—1

Global Config

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 232

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+