Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 606)

100

101

Utility Commands

606

ProSafe M4100 and M7100 Managed Switches

no sflow sampler

Use this command to reset the sFlow sampler instance to the default settings.

Format no sflow sampler {<rcvr-indx> | rate <sampling-rate> | maxheadersize

<size>}

Mode

sflow poller

A data source configured to collect counter samples is called a poller. Use this command to

enable a new sFlow poller instance for this data source if <rcvr_idx> is valid.

Format sflow poller {<rcvr-indx> | interval <poll-interval>}

Mode

no sflow poller

Use this command to reset the sFlow poller instance to the default settings.

Format no sflow poller {<rcvr-indx> | interval <poll-interval>}

Mode

Field Description

Receiver Index

The sFlow Receiver for this sFlow sampler to which flow samples are to be sent. A value

of zero (0) means that no receiver is configured, no packets will be sampled. Only active

receivers can be set. If a receiver expires, then all samplers associated with the receiver

will also expire. Possible values are 1-8. The default is 0.

Maxheadersize

The maximum number of bytes that should be copied from the sampler packet. The

range is 20-256. The default is 128. When set to zero (0), all the sampler parameters are

set to their corresponding default value.

Sampling Rate

The statistical sampling rate for packet sampling from this source. A sampling rate of 1

counts all packets. A value of zero (0) disables sampling. A value of N means that out of

N incoming packets, 1 packet will be sampled. The range is 1024-65536 and 0. The

default is 0.

Interface Config

Field Description

Receiver Index

Enter the sFlow Receiver associated with the sampler/poller. A value of zero (0) means

that no receiver is configured. The range is 1-8. The default is 0.

Poll Interval

Enter the sFlow instance polling interval. A poll interval of zero (0) disables counter

sampling. When set to zero (0), all the poller parameters are set to their corresponding

default value. The range is 0-86400. The default is 0. A value of N means once in N

seconds a counter sample is generated.

Interface Config

1 2 ... 601 602 603 604 605 606 607 608 609 610 611 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 606

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+