Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 511)

100

101

Power over Ethernet (PoE) Commands

511

ProSafe M4100 and M7100 Managed Switches

High Max Output Output

Intf Power Power Class Power Current Voltage Status Fault

(W) (W) (mA) (volt) Status

------ ------- ----- ------- ------ ------- ------- ------------------ ---------------

0/33 No 18.0 2 04.400 84 53.3 Delivering Power No Error

show poe pd

Use this command to get information about the PD ports. You can display information based on

each individual port or all the PD ports collectively.

Note: Only the GSM5212P supports this command.

• 1-event—PSE detects the PD in 1-event mode (802.1f)

• 2-event—PSE detects the PD in 2-event mode (802.1at)

• LLDP—PSE detects the PD in LLDP mode (802.1at)

• Powered—Receiving power from PSE

• Off—No power from the PSE (when main

AC is in used)

Example:

(switch) #show poe pd all

Intf Mode Class Detection Mode Status

---- ----- --------- ---------------- ----------

0/1 PD class 4 2-event powered

0/2 PD class 4 LLDP powered

Format show poe pd [<port> | all]

Mode Privileged EXEC

User EXEC

Term Definition

Intf Show the PD device interface number, only 0/1 or 0/2 on the GSM5212P.

In other devices, the table is empty. If <port-id> is not specified, all PD

ports are displayed.

Mode Displays the port POE role and is always PD.

Class Displays the POE class.

Detection Mode PD detection mode when getting power from the PSE:

Status Shows whether the port 0/1 or 0/2 is providing power:

1 2 ... 506 507 508 509 510 511 512 513 514 515 516 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 511

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+