Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 370)

100

101

IPv6 Commands

370

ProSafe M4100 and M7100 Managed Switches

show ipv6 neighbor

Use this command to display information about the IPv6 neighbors.

Format show ipv6 neighbor

Mode

clear ipv6 neighbors

Use this command to clear all entries IPv6 neighbor table or an entry on a specific interface.

Use the <slot/port> parameter to specify the interface.

Format clear ipv6 neighbors [<slot/port>]

Mode

show ipv6 route

This command displays the IPv6 routing table The <ipv6-address> specifies a specific

IPv6 address for which the best-matching route would be displayed. The

<ipv6-prefix/ipv6-prefix-length> specifies a specific IPv6 network for which the

matching route would be displayed. The <interface> specifies that the routes with

next-hops on the <interface> be displayed. The <protocol> specifies the protocol that

installed the routes. The <protocol> is one of the following keywords: connected, ospf,

static. The all specifies that all routes including best and non-best routes are displayed.

Otherwise, only the best routes are displayed.

A “T” flag appended to an IPv6 route indicates that it is an ECMP route, but only one of its

next hops has been installed in the forwarding table.

The forwarding table might limit the

number of ECMP routes or the number of ECMP groups. When an ECMP route cannot be

installed because the limit is reached, the route is installed with a single next hop. Such

truncated routes can be identified by a “T” after the interface name.

Privileged EXEC

Term Definition

Interface

The interface in slot/port format.

IPv6 Address

IPV6 address of neighbor or interface.

MAC Address

Link-layer Address.

IsRtr

Shows whether the neighbor is a router. If the value is TRUE, the neighbor is known to

be a router, and FALSE otherwise. A value of FALSE might not mean Note that routers

are not always known to be routers.

Neighbor State

State of neighbor cache entry. Possible values are Incomplete, Reachable, Stale, Delay,

Probe, and Unknown.

Last Updated

The time in seconds that has elapsed since an entry was added to the cache.

Privileged EXEC

1 2 ... 365 366 367 368 369 370 371 372 373 374 375 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 370

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+