Netgear Switch M4100-12G-POE+ User Manual download pdf (Page 238)

100

101

Routing Commands

238

ProSafe M4100 and M7100 Managed Switches

Maximum Paths The maximum number of next hops in an OSPF route

Routing for

Networks

The address ranges configured with an OSPF network command

Distance The administrative distance (or route preference) for intra-area, inter-area, and external

routes

Default Route

Advertise

Whether OSPF is configured to originate a default route

Always Whether default advertisement depends on having a default route in the common routing

table

Metric The metric configured to be advertised with the default route

Metric Type The metric type for the default route

Redist Source A type of routes that OSPF is redistributing

Metric The metric to advertise for redistributed routes of this type

Metric Type The metric type to advertise for redistributed routes of this type

Subnets Whether OSPF redistributes subnets of classful addresses, or only classful prefixes

Dist List A distribute list used to filter routes of this type. Only routes that pass the distribute list are

redistributed

Number of Active

Areas

The number of OSPF areas with at least one interface running on this router. Also broken

down by area type

ABR Status Whether the router is an area border router. A router is an area border router if it has

interfaces that are up in more than one area

ASBR Status Whether the router is an autonomous system boundary router. The router is an ASBR if it is

redistributing any routes or originating a default route

RIP

Split Horizon Mode Whether RIP advertises routes on the interface where they were received

Default Metric The metric assigned to redistributed routes

Default Route

Advertise

Whether this router is originating a default route

Distance The administrative distance for RIP routes

Redistribution A table showing information for each source protocol (connected, static, /jointfilesconvert/24872/bgp, and ospf). For

each of these sources the distribution list and metric are shown. Fields which are not

configured are left blank. For ospf, configured ospf match parameters are also shown

Interface The interfaces where RIP is enabled and the version sent and accepted on each interface

Parameter Description

1 2 ... 233 234 235 236 237 238 239 240 241 242 243 ... 767 768

Comments to this Manuals

No comments

Netgear Switch M4100-12G-POE+ User Manual Page 238

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100-12G-POE+