Netgear GSM7228PS User Manual download pdf (Page 295)

100

101

Routing Commands

295

ProSafe Managed Switch

distribute-list out (OSPF)

Use this command to specify the access list to filter routes received from the source protocol.

Format distribute-list <1-199> out {rip | static | connected}

Mode

no distribute-list out

Use this command to specify the access list to filter routes received from the source protocol.

Format no distribute-list <1-199> out {rip | static | connected}

Mode

exit-overflow-interval (OSPF)

This command configures the exit overflow interval for OSPF. It describes the number of

seconds after entering overflow state that a router will wait before attempting to leave the

overflow state. This allows the router to again originate non-default AS-external-LSAs. When

set to 0, the router will not leave overflow state until restarted. The range for seconds is 0 to

2147483647 seconds.

Default

Format exit-overflow-interval <seconds>

Mode

no exit-overflow-interval

This command configures the default exit overflow interval for OSPF.

Format no exit-overflow-interval

Mode

external-lsdb-limit (OSPF)

This command configures the external LSDB limit for OSPF. If the value is -1, then there is no

limit. When the number of non-default AS-external-LSAs in a router's link-state database

reaches the external LSDB limit, the router enters overflow state. The router never holds

more than the external LSDB limit non-default AS-external-LSAs in it database. The external

LSDB limit MUST be set identically in all routers attached to the OSPF backbone and/or any

regular OSPF area. The range for limit is -1 to 2147483647.

Default

Format external-lsdb-limit <limit>

Mode

Router OSPF Config

-1

Router OSPF Config

1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 295

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS