Netgear GSM7228PS User Manual download pdf (Page 638)

100

101

Management Commands

638

ProSafe Managed Switch

Network Interface Commands

This section describes the commands you use to configure a logical interface for

management access. To configure the management VLAN, see step on page 65.

enable (Privileged EXEC access)

Use this command to access the Privileged EXEC mode. From the Privileged EXEC mode,

you can configure the network interface.

Format enable

Mode

network parms

Use this command to set the IP address, subnet mask and gateway of the device. The IP

address and the gateway must be on the same subnet.

Format network parms <ipaddr> <netmask> [<gateway>]

Mode

network protocol

Use this command to specify the network configuration protocol to be used. If you modify this

value, change is effective immediately. If you use the bootp parameter, the switch

periodically sends requests to a BootP server until a response is received. If you use the

dhcp parameter, the switch periodically sends requests to a DHCP server until a response is

received. If you use the none parameter, you must configure the network information for the

switch manually.

Default

Format network protocol {none | bootp | dhcp}

Mode

network mac-address

Use this command to set locally administered MAC addresses. The following rules apply:

• Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally

administered (b'0') or locally administered (b'1').

• Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual

address (b'0') or a group address (b'1').

• The second character, of the twelve character macaddr, must be 2, 6, A or E.

User EXEC

Privileged EXEC

none

Privileged EXEC

1 2 ... 633 634 635 636 637 638 639 640 641 642 643 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 638

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS