Netgear GSM7228PS User Manual download pdf (Page 377)

100

101

IPv6 Commands

377

ProSafe Managed Switch

no ipv6 enable

Use this command to disable IPv6 routing on an interface.

Format no ipv6 enable

Mode

ipv6 address

Use this command to configure an IPv6 address on an interface, including tunnel and

loopback interfaces, and to enable IPv6 processing on this interface. You can assign multiple

globally reachable addresses to an interface by using this command. You do not need to

assign a link-local address by using this command since one is automatically created. The

<prefix> field consists of the bits of the address to be configured. The <prefix_length>

designates how many of the high-order contiguous bits of the address make up the prefix.

You can express IPv6 addresses in eight blocks. Also of note is that instead of a period, a

colon now separates each block. For simplification, leading zeros of each 16 bit block can be

omitted. One sequence of 16 bit blocks containing only zeros can be replaced with a double

colon “::”, but not more than one at a time (otherwise it is no longer a unique representation).

• Dropping zeros:

3ffe:ffff:100:f101:0:0:0:1 becomes 3ffe:ffff:100:f101::1

• Local host: 0000:0000:0000:0000:0000:0000:0000:0001 becomes ::1

• Any host: 0000:0000:0000:0000:0000:0000:0000:0000 becomes ::

The hexadecimal letters in the IPv6 addresses are not case-sensitive. An example of an IPv6

prefix and prefix length is

3ffe:1::1234/64.

The optional [eui-64] field designates that IPv6 processing on the interfaces was enabled

using an EUI-64 interface ID in the low order 64 bits of the address. If you use this option, the

value of <prefix_length> must be 64 bits.

Format ipv6 address <prefix>/<prefix_length> [eui64]

Mode

no ipv6 address

Use this command to remove all IPv6 addresses on an interface or specified IPv6 address.

The <prefix> parameter consists of the bits of the address to be configured. The

<prefix_length> designates how many of the high-order contiguous bits of the address

comprise the prefix. The optional [eui-64] field designates that IPv6 processing on the

interfaces was enabled using an EUI-64 interface ID in the low order 64 bits of the address.

If you do not supply any parameters, the command deletes all the IPv6 addresses on an

interface.

Format no ipv6 address [<prefix>/<prefix_length>] [eui64]

Mode

Interface Config

1 2 ... 372 373 374 375 376 377 378 379 380 381 382 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 377

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS