Netgear GSM7228PS User Manual download pdf (Page 520)

100

101

Power over Ethernet (PoE) Commands

520

ProSafe Managed Switch

no poe detection

Use this command to set the detection mode to the default on a global basis or per interface.

poe high-power

Use this command to switch a port from 802.3af mode to high-power mode. This mode is used to

power up devices that require more power than the current IEEE 802.3af power (more than

12.95 watts at the PD). There are three options:

• legacy—Use this mode if the device can power up (more than 12.95 watts) with higher

current and it cannot identify itself as a Class 4 device.

• Pre-dot3at—Use this mode if the device cannot identify itself as a Class 4 device and it

does not have LLDP support.

• Dot3at—Use this mode if the device is a Class 4 device capable of figuring out power

requirements through 2-event classification or LLDP.

no poe high-power

Use this command to disable the high-power mode. The port will support only IEEE 902.3af

devices.

This command works on a global basis or per interface.

poe power limit

Use this command to configure the type of power limit for a port. If the power limit type is

“user-defined,” the command also allows you to configure a maximum power limit.

There are three options:

• class-based—Allows the port to draw up to the maximum power based on the

classification of the device connected.

• none—Allows the port to draw up to Class 0 maximum power if it is in low-power mode

and up to Class 4 maximum power if it is in high-power mode.

Format no poe detection

Mode Global Config

Interface Config

Format poe high-power {legacy | pre-dot3at | dot3at}

Mode Interface Config

Default dot3at

Format no poe high-power

Mode Interface Config

1 2 ... 515 516 517 518 519 520 521 522 523 524 525 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 520

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS