Netgear GSM7228PS User Manual download pdf (Page 12)

100

101

Using the Command-Line Interface

ProSafe Managed Switch

Name with Spaces” forces the system to accept the spaces. Empty strings (““) are not valid

user-defined strings. Table 2 describes common parameter values and value formatting.

Table 2. Parameter Descriptions

a (32 bits)

a.b (8.24 bits)

a.b.c (8.8.16 bits)

0xn (CLI assumes hexadecimal format)

0n (CLI assumes octal format with leading zeros)

Unit/Slot/Port Naming Convention

Managed switch software references physical entities such as cards and ports by using a

unit/slot/port naming convention. The software also uses this convention to identify certain

logical entities, such as Port-Channel interfaces.

The slot number has two uses. In the case of physical ports, it identifies the card containing

the ports. In the case of logical and CPU ports it also identifies the type of interface or port.

Table 3. Type of Slots

Parameter Description

ipaddr This parameter is a valid IP address. You can enter the IP address in the following formats:

a.b.c.d (8.8.8.8)

In addition to these formats, the CLI accepts decimal, hexadecimal and octal formats

through the following input formats (where n is any valid hexadecimal, octal or decimal

number):

n (CLI assumes decimal format)

ipv6-address

FE80:0000:0000:0000:020F:24FF:FEBF:DBCB, or

FE80:0:0:0:20F:24FF:FEBF:DBCB, or

FE80::20F24FF:FEBF:DBCB, or

FE80:0:0:0:20F:24FF:128:141:49:32

For additional information, refer to RFC 3513.

Interface or

unit/slot/port

Valid slot and port number separated by forward slashes. For example, 0/1 represents slot

number 0 and port number 1.

Logical Interface

Represents a logical slot and port number. This is applicable in the case of a port-channel

(LAG). You can use the logical unit/slot/port to configure the port-channel.

Character strings Use double quotation marks to identify character strings, for example, “System Name with

Spaces”. An empty string (“”) is not valid.

Slot Type Description

Physical slot numbers Physical slot numbers begin with zero, and are allocated up to the maximum

number of physical slots.

Logical slot numbers Logical slots immediately follow physical slots and identify port-channel (LAG) or

router interfaces.

CPU slot numbers The CPU slots immediately follow the logical slots.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 12

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS