Netgear GSM7228PS User Manual download pdf (Page 619)

100

101

Utility Commands

619

ProSafe Managed Switch

sflow sampler

A data source configured to collect flow samples is called a poller. Use this command to

configure a new sFlow sampler instance for this data source if <rcvr_idx> is valid.

Format sflow sampler {<rcvr-indx> | rate <sampling-rate> | maxheadersize

<size>}

Mode

no sflow sampler

Use this command to reset the sFlow sampler instance to the default settings.

Format no sflow sampler {<rcvr-indx> | rate <sampling-rate> | maxheadersize

<size>}

Mode

sflow poller

A data source configured to collect counter samples is called a poller. Use this command to

enable a new sFlow poller instance for this data source if <rcvr_idx> is valid.

Format sflow poller {<rcvr-indx> | interval <poll-interval>}

Mode

Interface Config

Field Description

Receiver Index

The sFlow Receiver for this sFlow sampler to which flow samples are to be sent. A value

of zero (0) means that no receiver is configured, no packets will be sampled. Only active

receivers can be set. If a receiver expires, then all samplers associated with the receiver

will also expire. Possible values are 1-8. The default is 0.

Maxheadersize

The maximum number of bytes that should be copied from the sampler packet. The

range is 20-256. The default is 128. When set to zero (0), all the sampler parameters are

set to their corresponding default value.

Sampling Rate

The statistical sampling rate for packet sampling from this source. A sampling rate of 1

counts all packets. A value of zero (0) disables sampling. A value of N means that out of

N incoming packets, 1 packet will be sampled. The range is 1024-65536 and 0. The

default is 0.

Interface Config

1 2 ... 614 615 616 617 618 619 620 621 622 623 624 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 619

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS