Netgear GSM7228PS User Manual download pdf (Page 141)

100

101

Switching Commands

141

ProSafe Managed Switch

show monitor session

This command displays the Port monitoring information for a particular mirroring session.

Note: The <session-id> parameter is an integer value used to identify

the session. In the current version of the software, the

<session-id> parameter is always one (1)

Static MAC Filtering

The commands in this section describe how to configure static MAC filtering. Static MAC

filtering allows you to configure destination ports for a static multicast MAC filter irrespective

of the platform.

macfilter

This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN

<vlanid>. The value of the <macaddr> parameter is a 6-byte hexadecimal number in the

format of b1:b2:b3:b4:b5:b6. The restricted MAC Addresses are: 00:00:00:00:00:00,

01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and

FF:FF:FF:FF:FF:FF. The <vlanid> parameter must identify a valid VLAN.

The number of static mac filters supported on the system is different for MAC filters where

source ports are configured and MAC filters where destination ports are configured.

• For unicast MAC address filters and multicast MAC address filters with source port lists,

the maximum number of static MAC filters supported is 20.

Format show monitor session <session-id>

Mode

Privileged EXEC

Term Definition

Session ID

An integer value used to identify the session. Its value can be anything between 1 and

the maximum number of mirroring sessions allowed on the platform.

Admin Mode

Indicates whether the Port Mirroring feature is enabled or disabled for the session

identified with <session-id>. The possible values are Enabled and Disabled.

Probe Port

Probe port (destination port) for the session identified with

<session-id>. If probe port

is not set then this field is blank.

Mirrored Port

The port, which is configured as mirrored port (source port) for the session identified with

<session-id>. If no source port is configured for the session then this field is blank.

Type

Direction in which source port configured for port mirroring. Types are tx for transmitted

packets and rx for receiving packets.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 141

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS