Netgear GSM7228PS User Manual download pdf (Page 563)

100

101

Utility Commands

563

ProSafe Managed Switch

Using the options described below, you can specify the initial and maximum time-to-live

(TTL) in probe packets, the maximum number of failures before termination, the number of

probes sent for each TTL, and the size of each probe.

ipaddr|hostname

initTtl

maxTtl

maxFail

interval

count

port

size

source

The following are examples of the CLI command.

traceroute Success:

(Switch) # traceroute 10.240.10.115 initTtl 1 maxTtl 4 maxFail 0 interval 1 count 3 port

33434 size 43

Traceroute to 10.240.10.115 ,4 hops max 43 byte packets:

1 10.240.4.1 708 msec 41 msec 11 msec

2 10.240.10.115 0 msec 0 msec 0 msec

Hop Count = 1 Last TTL = 2 Test attempt = 6 Test Success = 6

traceroute Failure:

(Switch) # traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3

port 33434 size 43

Traceroute to 10.40.1.1 ,30 hops max 43 byte packets:

1 10.240.4.1 19 msec 18 msec 9 msec

2 10.240.1.252 0 msec 0 msec 1 msec

3 172.31.0.9 277 msec 276 msec 277 msec

4 10.254.1.1 289 msec 327 msec 282 msec

5 10.254.21.2 287 msec 293 msec 296 msec

6 192.168.76.2 290 msec 291 msec 289 msec

7 0.0.0.0 0 msec *

Parameter Description

The ipaddr value should be a valid IP address. The hostname value should

be a valid hostname.

Use initTtl to specify the initial time-to-live (TTL), the maximum number of router

hops between the local and remote system. Range is 0 to 255.

Use maxTtle to specify the maximum TTL. Range is 1 to 255.

Use maxFail to terminate the traceroute after failing to receive a response for this

number of consecutive probes. Range is 0 to 255.

Use interval to specify the time between probes, in seconds. Range is 1 to 60

seconds.

Use the optional count parameter to specify the number of probes to send for each

TTL value. Range is 1 to 10 probes.

Use the optional port parameter to specify destination UDP port of the probe. This

should be an unused port on the remote destination system. Range is 1 to 65535.

Use the optional size parameter to specify the size, in bytes, of the payload of the

Echo Requests sent. Range is 0 to 65507 bytes.

Use the optional source parameter to specify the source IP address or interface for

the traceroute.

1 2 ... 558 559 560 561 562 563 564 565 566 567 568 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 563

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS