Netgear GSM7228PS User Manual download pdf (Page 711)

100

101

Management Commands

711

ProSafe Managed Switch

Configuration Scripting Commands

Configuration Scripting allows you to generate text-formatted script files representing the

current configuration of a system. You can upload these configuration script files to a PC or

UNIX system and edit them. Then, you can download the edited files to the system and apply

the new configuration. You can apply configuration scripts to one or more switches with no or

minor modifications.

Use the show running-config command (see show running-config on page 547) to

capture the running configuration into a script. Use the copy command (see copy on

page 569) to transfer the configuration script to or from the switch.

You should use scripts on systems with default configuration; however, you are not prevented

from applying scripts on systems with non-default configurations.

Scripts must conform to the following rules:

• Script files are not distributed across the stack, and only live in the unit that is the master

unit at the time of the file download.

• The file extension must be “.scr”.

• A maximum of ten scripts are allowed on the switch.

• The combined size of all script files on the switch shall not exceed 2048 KB.

• The maximum number of configuration file command lines is 2000.

You can type single-line annotations at the command prompt to use when you write test or

configuration scripts to improve script readability. The exclamation point (!) character flags

the beginning of a comment. The comment flag character can begin a word anywhere on the

command line, and all input following this character is ignored. Any command line that begins

with the “!” character is recognized as a comment line and ignored by the parser.

The following lines show an example of a script:

! Script file for displaying management access

show telnet !Displays the information about remote connections

! Display information about direct connections

show serial

! End of the script file!

Note: To specify a blank password for a user in the configuration script,

you must specify it as a space within quotes. For example, to

change the password for user jane from a blank password to

hello, the script entry is as follows:

users passwd jane

" "

1 2 ... 706 707 708 709 710 711 712 713 714 715 716 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 711

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS