Netgear GSM7228PS User Manual Page 509

  • Download
  • Add to my manuals
  • Print
  • Page
    / 799
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 508
Quality of Service (QoS) Commands
509
ProSafe Managed Switch
Note: If voice VLAN and Auto-VoIP are enabled at the same time, then
one of them is operational. If the connected phone is LLDP-MED
capable, then voice VLAN has precedence over the Auto VoIP and
Auto VoIP is operational if the phone does not support LLDP-MED.
auto-voip {protocol-based | oui-based}
This command is used to configure auto VoIP mode. The supported modes are
protocol-based and oui-based. Protocol based auto VoIP prioritizes the voice data based on
the layer 4 port used for the voice session. OUI based auto VOIP prioritizes the phone traffic
based on the known OUI of the phone.
Format auto-voip {protocol-based | oui-based}
Mode
• Global Config
• Interface Config
Default
no auto-voip {protocol-based | oui-based}
This command is used to set default mode.
Format no auto-voip {protocol-based | oui-based}
Mode
• Global Config
• Interface Config
auto-voip oui
This command is used to configure an OUI for Auto VoIP. The traffic from the configured OUI
will get the highest priority over the other traffic.
Format auto-voip oui <oui-prefix> oui-desc <string>
Mode
Default
no auto-voip oui
This command is to delete already configured OUI.
Format no auto-voip oui <oui-prefix>
Mode
oui-based
Global Config
A list of known OUIs is present
Global Config
Page view 508
1 2 ... 504 505 506 507 508 509 510 511 512 513 514 ... 798 799

Comments to this Manuals

No comments