Netgear GSM7228PS User Manual download pdf (Page 504)

100

101

Quality of Service (QoS) Commands

504

ProSafe Managed Switch

forwarded to the specified <unit/slot/port>. The assign-queue and redirect

parameters are only valid for a permit rule.

The time-range parameter allows imposing time limitation on the IPv6 ACL rule as defined by

the parameter <time-range-name>. If a time range with the specified name does not exist and

the IPv6 ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the

ACL rule is applied immediately. If a time range with specified name exists and the IPv6 ACL

containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is

applied when the time-range with specified name becomes active. The ACL rule is removed

when the time-range with specified name becomes inactive.

Format {deny | permit} {every | {{icmp | igmp | ipv6 | tcp | udp |

<number>}[log] [timerange

<time-range-name>] [assign-queue <queue-id>] [{mirror | redirect}

<unit/slot/port>]

Mode

ipv6 traffic-filter

This command either attaches a specific IPv6 ACL identified by <name> to an interface or

associates with a VLAN ID in a given direction. The <name> parameter must be the name of

an existing IPv6 ACL.

An optional sequence number may be specified to indicate the order of this mac access list

relative to other IPv6 access lists already assigned to this interface and direction. A lower

number indicates higher precedence order. If a sequence number is already in use for this

interface and direction, the specifiedIPv6 access list replaces the currently attached IPv6

access list using that sequence number. If the sequence number is not specified for this

command, a sequence number that is one greater than the highest sequence number

currently in use for this interface and direction is used.

This command specified in Interface Config mode only affects a single interface, whereas the

Global Config mode setting is applied to all interfaces. The vlan keyword is only valid in the

Global Config mode. The Interface Config mode command is only available on platforms that

support independent per-port class of service queue configuration.

Note: You should be aware that the <out> option may or may not be

available, depending on the platform.

IPv6-Access-List Config

Format ipv6 traffic-filter <name> {{control-plane|in|out}|vlan <vlan-id>

{in|out}} [sequence <1-4294967295>]

Modes

• Global Config

• Interface Config

1 2 ... 499 500 501 502 503 504 505 506 507 508 509 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 504

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS