Netgear GSM7228PS User Manual download pdf (Page 496)

100

101

Quality of Service (QoS) Commands

496

ProSafe Managed Switch

positions that are not used. In contrast, a wildcard mask has (0’s) in a bit position that

must be checked. A ‘1’ in a bit position of the ACL mask indicates the corresponding bit

can be ignored.

access-list

This command creates an IP Access Control List (ACL) that is identified by the access list

number, which is 1-99 for standard ACLs or 100-199 for extended ACLs.

IP Standard ACL:

Format access-list <1-99> {deny | permit} {every | <srcip> <srcmask>} [log]

[rate-limit <1-4294967295> <1-128>][assign-queue <queue-id>]

[{mirror | redirect} <unit/slot/port>]

Mode

IP Extended ACL:

Format access-list <100-199> {deny | permit} {every | {{icmp | igmp | ip |

tcp | udp | <number>} <srcip> <srcmask>[{eq {<portkey> | <0-65535>}

<dstip> <dstmask> [{eq {<portkey>| <0-65535>}] [precedence

<precedence> | tos <tos> <tosmask> | dscp <dscp>] [log] [rate-limit

<1-4294967295> <1-128>] [assign-queue <queue-id>] [{mirror |

redirect} <unit/slot/port>]

Mode

Global Config

Parameter Description

<1-99> or <100-199>

Range 1 to 99 is the access list number for an IP standard ACL.

Range 100 to 199 is the access list number for an IP extended ACL.

{deny | permit}

Specifies whether the IP ACL rule permits or denies an action.

every

Match every packet

{icmp | igmp | ip | tcp | udp

| <number>}

Specifies the protocol to filter for an extended IP ACL rule.

Specifies a source IP address and source netmask for match

condition of the IP ACL rule.

[{eq {<portkey> |

<0-65535>}]

Specifies the source layer 4 port match condition for the IP ACL rule.

You can use the port number, which ranges from 0-65535, or you

specify the <portkey>, which can be one of the following

keywords: domain, echo, ftp, ftpdata, http, smtp,

snmp, telnet, tftp, and www-http. Each of these keywords

translates into its equivalent port number, which is used as both the

start and end of a port range.

Specifies a destination IP address and netmask for match condition

of the IP ACL rule.

1 2 ... 491 492 493 494 495 496 497 498 499 500 501 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 496

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS