Netgear GSM7228PS User Manual download pdf (Page 477)

100

101

Quality of Service (QoS) Commands

477

ProSafe Managed Switch

Note: This command does not validate the protocol number value against

the current list defined by IANA.

match source-address mac

This command adds to the specified class definition a match condition based on the source

MAC address of a packet. The <address> parameter is any layer 2 MAC address formatted

as six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The

<macmask> parameter is a layer 2 MAC address bit mask, which may not be contiguous,

and is formatted as six, two-digit hexadecimal numbers separated by colons (e.g.,

ff:07:23:ff:fe:dc).

Default

Format match source-address mac <address> <macmask>

Mode

match srcip

This command adds to the specified class definition a match condition based on the source

IP address of a packet. The <ipaddr> parameter specifies an IP address. The <ipmask>

parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1

bits.

Default

Format match srcip <ipaddr> <ipmask>

Mode

match srcip6

This command adds to the specified class definition a match condition based on the source

IP address of a packet.

Default

none

Format match protocol {<protocol-name> | <0-255>}

Mode

Class-Map Config

Ipv6-Class-Map Config

none

Class-Map Config

Ipv6-Class-Map Config

none

Class-Map Config

Default

none

1 2 ... 472 473 474 475 476 477 478 479 480 481 482 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 477

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS