Netgear GSM7228PS User Manual download pdf (Page 475)

100

101

Quality of Service (QoS) Commands

475

ProSafe Managed Switch

To specify the match condition using a numeric notation, one layer 4 port number is required.

The port number is an integer from 0 to 65535.

Default

Format match dstl4port {<portkey> | <0-65535>}

Mode

match ip dscp

This command adds to the specified class definition a match condition based on the value of

the IP DiffServ Code Point (DSCP) field in a packet, which is defined as the high-order six

bits of the Service Type octet in the IP header (the low-order two bits are not checked).

The <dscpval> value is specified as either an integer from 0 to 63, or symbolically through

one of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42,

af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.

Note: The ip dscp, ip precedence, and ip tos match conditions are

alternative ways to specify a match criterion for the same Service

Type field in the IP header, but with a slightly different user notation.

match ip precedence

This command adds to the specified class definition a match condition based on the value of

the IP Precedence field in a packet, which is defined as the high-order three bits of the

Service Type octet in the IP header (the low-order five bits are not checked). The precedence

value is an integer from 0 to 7.

Note: The IP DSCP, IP Precedence, and IP ToS match conditions are

alternative ways to specify a match criterion for the same Service

Type field in the IP header, but with a slightly different user notation.

none

Class-Map Config

Ipv6-Class-Map Config

Default

none

Format match ip dscp <dscpval>

Mode

Class-Map Config

Ipv6-Class-Map Config

1 2 ... 470 471 472 473 474 475 476 477 478 479 480 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 475

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS