Netgear GSM7228PS User Manual download pdf (Page 253)

100

101

Routing Commands

253

ProSafe Managed Switch

encapsulation

This command configures the link layer encapsulation type for the packet. The encapsulation

type can be ethernet or snap.

Default

Format encapsulation {ethernet | snap}

Mode

Note: Routed frames are always ethernet encapsulated when a frame is

routed to a VLAN.

clear ip route all

This command removes all the route entries learned over the network.

Format clear ip route all

Mode

Protocol

Total

Number of

Routes

clear ip route counters

This command resets to zero the IPv4 routing table counters reported in show ip route

summary. The command resets only the event counters. Counters that report the current

state of the routing table, such as the number of routes of each type, are not reset.

Format clear ip route counters

Mode

show ip brief

This command displays all the summary information of the IP, including the ICMP rate limit

configuration and the global ICMP Redirect configuration.

ethernet

Interface Config

Privileged EXEC

Tells which protocol added the specified route. The possibilities are: local, static, OSPF, or

RIP.

The total number of routes.

Privileged EXEC

Format show ip brief

Modes

• Privileged EXEC

• User EXEC

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 253

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS