Netgear GSM7228PS User Manual download pdf (Page 23)

100

101

Stacking Commands

ProSafe Managed Switch

Note: If the management unit is renumbered, then the running

configuration is no longer applied (that is, the stack acts as if the

configuration had been cleared).

movemanagement

This command moves the Primary Management Unit functionality from one switch to another.

The <fromunit> is the switch identifier on the current Primary Management Unit. The

<tounit> is the switch identifier on the new Primary Management Unit. Upon execution,

the entire stack (including all interfaces in the stack) is unconfigured and reconfigured with

the configuration on the new Primary Management Unit. After the reload is complete, all

stack management capability must be performed on the new Primary Management Unit. To

preserve the current configuration across a stack move, execute the copy

system:running-config nvram:startup-config (in Privileged EXEC) command

before performing the stack move. A stack move causes all routes and layer 2 addresses to

be lost. This command is executed on the Primary Management Unit. The system prompts

you to confirm the management move.

Note: The movemanagement command does not NSF (non-stop

forwarding). To move the management unit to the backup unit, use

initiate failover instead. For more information, see

initiate

failover on page 33.

standby

Use this command to configure a unit as a Standby Management Unit (STBY).

Format switch <oldunit> renumber <newunit>

Mode Global Config

Format movemanagement <fromunit> <tounit>

Mode Stack Global Config

Format standby <unit number>

Mode Stack Global Config

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 798 799

Comments to this Manuals

No comments

Netgear GSM7228PS User Manual Page 23

Comments to this Manuals

Related products and manuals for Networking Netgear GSM7228PS