Netgear WNDAP360 User Manual download pdf (Page 64)

Management

ProSafe Dual Band Wireless-N Access Point WNDAP360

Figure 35.

5. Specify the following information:

• Firmware File

Name. The name of the unzipped software file.

• TFT

P Server IP. The IP address of your TFTP server.

6. Click Apply

to initiate the upgrade process.

During the upgrade process, the wireless access point automatically restarts. The

upgra

de process typically takes several minutes. When the Test LED turns off, wait a few

more seconds before doing anything with the wireless access point.

7. V

erify that the new software file has been installed by selecting Monitoring > System. The

System screen displays (see Figure 42 on p

age 70). The firmware version is shown in the

Access Point Information section of the screen.

Manage the Configuration File or Reset to Factory

Defaults

The wireless access point settings are stored in the configuration file. You can save this file

(back it up) to a computer, restore it from a computer, or reset it to factory default settings.

Save the Configuration

 To save your settings:

1. Select M

aintenance > Upgrade > Backup Settings. The Backup Settings screen

displays (see the following figure).

2. Click Backup. Y

our browser extracts the configuration file (the file name is config) from the

wireless access point and prompts you for a location on your computer to store the file.

3. Fo

llow the instructions of your browser to save the file.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 136 137

No comments

Netgear WNDAP360 User Manual Page 64