Netgear WNDAP360 User Manual download pdf (Page 26)

Installation and Basic Configuration

ProSafe Dual Band Wireless-N Access Point WNDAP360

6. Click Apply to save your settings and enable the selected wireless mode.

Note: The radio wave icon ( ) displays next to the enabled wireless

mode.

11ng mode only

(continued)

Ext Channel

Offset

When you select a channel width of Dynamic 20/40 MHz or

40 MHz, you also need to select the offset for the extension

channel from the Ext Channel Offset drop-down list. In

addition to the default value Auto, you can also select Upper

or Lower.

Note: This field is not applicable when the channel width is

t to 20 MHz.

Guard Interval From the drop-down list, select the guard interval to protect

transmissio

ns from interference. In addition to the default

value Auto, you can also select Long - 800 ns. Some legacy

devices can operate only with a long guard interval.

11b and 11/jointfilesconvert/44179/bg modes

Data Rate From the drop-down list, select the transmit data rate of the

wireless network. The default setting is Best. For a list of all

options that you can select from in 11b mode and 11/jointfilesconvert/44179/bg mode,

see Factory Default Settings in Appendix A.

Output Power From the drop-down list, select the transmission power of the wireless access

int: Full, Half, Quarter, Eighth, Minimum. The default is Full.

Note: Increasing the power improves performance, but if two or more wireless

ccess points are operating in the same area and on the same channel,

interference can occur.

Note: Make sure that you comply with the regul

atory requirements for total radio

frequency (RF) output power in your country.

Table 6. Basic 2.4-GHz Band Wireless Settings (Continued)

Field Descriptions

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 136 137

No comments

Netgear WNDAP360 User Manual Page 26