Netgear Switch M4100 User Manual download pdf (Page 60)

100

101

Chapter 4. Port Routing | 60

4. Port Routing

This chapter provides the following sections:

• Port Routing Configuration on page 61

• Enable Routing for the Switch on page 62

• Enable Routing for Ports on the Switch on page 62

• Add a Default Route on page 65

• Add a Static Route on page 66

The first networks were small enough for the end stations to communicate directly. As networks

grew, Layer 2 bridging was used to segregate traffic, a technology that worked well for unicast

traffic, but had problems coping with large quantities of multicast packets. The next major

development was routing, where packets were examined and redirected at Layer 3. End stations

needed to know how to reach their nearest router, and the routers had to interpret the network

topology so that they could forward traffic. Although bridges tended to be faster than routers,

using routers allowed the network to be partitioned into logical subnetworks, which restricted

multicast traffic and also facilitated the development of security mechanisms.

An end station specifies the destination station’s Layer 3 address in the packet’s IP header, but

sends the packet to the MAC address of a router. When the Layer 3 router receives the packet, it

will minimally:

• Look up the Layer 3 address in its address table to determine the outbound port.

• Update the Layer 3 header.

• Re-create the Layer 2 header.

The router’s IP address is often statically configured in the end station, although the M4100 and

M7100 Managed Switch supports protocols such as DHCP that allow the address to be assigned

dynamically. Likewise, you can assign some of the entries in the routing tables used by the

router statically, but protocols such as RIP and OSPF allow the tables to be created and updated

dynamically as the network configuration changes.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 558 559

Comments to this Manuals

No comments

Netgear Switch M4100 User Manual Page 60

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100