Netgear Switch M4100 User Manual download pdf (Page 366)

100

101

366 | Chapter 19. Switch Stacks

ProSafe M4100 and M7100 Managed Switches

CLI: Renumber Stack Members

Note: When issuing a command (such as move management, or

renumber), NETGEAR recommends that you wait until the

command has fully executed before issuing the next command. For

example, if a reset is issued to a stack member, use the show port

command to verify that the switch has re-merged with the stack, and

all ports are joined before issuing the next command.

• If specific numbering is required, NETGEAR recommends that you assign stack members

their numbers when they are first installed and configured in the stack, if possible.

• If the stack unit number for a switch is unused, you can renumber the unit by using the

switch <oldunit-id> renumber <newunit-id> CLI command. This command is

found in global config mode.

• If the newunit-id has been preconfigured, you might need to remove the newunit-id from

the configuration before renumbering the unit.

• If you need to reassign multiple existing stack unit numbers, the configuration could

become mismatched.

To avoid this situation, NETGEAR recommends that you power

down all switches except the master, and then add them back one at a time using the

procedure in Section Add Switches to an Operating Stack on page 361.

Web Interface: Renumber Stack Members

1. Renumber the stacking member’s ID from 3 to 2.

a. Select System > Management > Basic > Stack Configuration.

A screen similar to the following displays.

b. Under Stack Configuration, scroll down and select the Unit ID 3 check box.

c. In the Unit ID list, select 2.

d. Click Apply.

1 2 ... 361 362 363 364 365 366 367 368 369 370 371 ... 558 559

Comments to this Manuals

No comments

Netgear Switch M4100 User Manual Page 366

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100