Netgear Switch M4100 User Manual download pdf (Page 65)

100

101

Chapter 4. Port Routing | 65

ProSafe M4100 and M7100 Managed Switches

Now 1/0/5 appears in the Interface field at the top.

c. Enter the following information:

• In the IP Address field, enter 192.150.5.1.

• In the Subnet Mask field, enter 255.255.255.0.

• In the Routing Mode field, select Enable.

d. Click Apply to save the settings.

Add a Default Route

When IP routing takes place on a switch, a routing table is needed for the switch to forward

the packet based on the destination IP address. The route entry in the routing table can

either be created dynamically through routing protocols like RIP and OSPF, or be manually

created by the network administrator. The route created manually is called the static or

default route.

A default route is used for forwarding the packet when the switch cannot find a match in the

routing table for an IP packet.

The following example shows how to create a default route.

CLI: Add a Default Route

(FSM7338S) (Config) #ip route default?

<nexthopip> Enter the IP Address of the next router.

(FSM7328S) (Config)#ip route default 10.10.10.2

Note: IP subnet 10.10.10.0 should be configured using either port routing

(Enable Routing for Ports on the Switch on page 62) or VLAN

routing (see Set Up VLAN Routing for the VLANs and the Switch on

page 73).

Web Interface: Add a Default Route

1. Select Routing > Routing Table > Basic > Route Configuration.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 558 559

Comments to this Manuals

No comments

Netgear Switch M4100 User Manual Page 65

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100