Netgear Switch M4100 User Manual Page 104

  • Download
  • Add to my manuals
  • Print
  • Page
    / 559
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 103
104 | Chapter 7. OSPF
ProSafe M4100 and M7100 Managed Switches
2. Set the router ID to 2.2.2.2.
(Netgear Switch) (Config-router)#router-id 2.2.2.2
3. Configure area 0.0.0.1 as a stub area.
(Netgear Switch) (Config-router)#area 0.0.0.1 stub
4. Enable OSPF area 0.0.0.1 on the 1/0/15.
(Netgear Switch) (Config-router)#exit
(Netgear Switch) (Config-router)#exit
(Netgear Switch) (Config)#interface 1/0/15
(Netgear Switch) (Interface 1/0/15)#routing
(Netgear Switch) (Interface 1/0/15)#ip address 192.168.20.2 255.255.255.0
(Netgear Switch) (Interface 1/0/15)#ip ospf
(Netgear Switch) (Interface 1/0/15)#ip ospf areaid 0.0.0.1
(Netgear Switch) (Interface 1/0/15)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #show ip route
Total Number of Routes......................... 2
Network Subnet Next Hop Next Hop
Address Mask Protocol Intf IP Address
--------------- --------------- ------------ --------- ---------------
0.0.0.0 0.0.0.0 OSPF Inter 1/0/15 192.168.20.1
192.168.20.0 255.255.255.0 Local 1/0/15 192.168.20.2
Web Interface: Configure Area 1 as a Stub Area on A2
1. Enable IP routing on the switch.
a. Select Routing > IP > Basic > IP Configuration.
A screen similar to the following displays.
Page view 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 558 559

Comments to this Manuals

No comments