Netgear Switch M4100 User Manual Page 543

  • Download
  • Add to my manuals
  • Print
  • Page
    / 559
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 542
Chapter 32. Captive Portal | 543
ProSafe M4100 and M7100 Managed Switches
You can enable captive portal on all the physical ports on the switch. It is not supported for VLAN
interfaces, loopback interfaces or logical interfaces. The captive portal feature uses
MAC-aaddress based authentication and not port-based authentication. This means that all the
clients connected to the captive portal interface must be authenticated before they can get
access to the network.
Clients connecting to the captive portal interface have three states; unknown, unauthenticated,
and authenticated.
Unknown. In the unknown state, the captive portal does not redirect HTTP/S traf
fic to the
switch, but instead asks the switch whether the client is authenticated or unauthenticated.
Unathenticated.
The captive portal directs the HTTP/S traffic to the switch so that the
client can authenticate with the switch.
Authenticated.
After successful authentication, the client is placed in authenticated
state. In this state, all the traffic emerging from the client is forwarded through the switch.
Captive Portal Configuration
This section introduces the objects that make up the captive portal and describes the
interaction between the captive portal and the network administrator. It explains what
configurations are visible to the network administrator and enumerates the events.
All the configurations included in this section are managed using the CLI, the Web Interface,
and SNMP
, with one exception; to customize the captive portal Web page, you must use the
Web Interface.
The captive portal configuration provides the network administrator control over verification
and authentication, assignment to interfaces, client sessions, and W
eb page customization.
You can create multiple captive portal configuration instances. Each captive portal
configuration contains various flags and definitions used to control client access and content
to customize the user verification Web page. A captive portal configuration can be applied to
one or more interfaces. An interface can only be a physical port on the switch. Software
release 8.0 and newer versions can contain up to 10 captive portal configurations.
Enable Captive Portal
CLI: Enable Captive Portal
1. Enable captive portal on the switch.
(Netgear Switch) (config)#captive-portal
(Netgear Switch) (Config-CP)#enable
Page view 542
1 2 ... 538 539 540 541 542 543 544 545 546 547 548 ... 558 559

Comments to this Manuals

No comments