Netgear Switch M4100 User Manual download pdf (Page 80)

100

101

80 | Chapter 6. RIP

ProSafe M4100 and M7100 Managed Switches

CLI: Enable RIP for Ports 1/0/2 and 1/0/3

This command sequence enables RIP for ports 1/0/2 and 1/0/3. Authentication defaults to

none, and no default route entry is created. The commands specify that both ports receive

both RIPv1 and RIPv2 frames, but send only RIPv2-formatted frames.

(Netgear Switch) #config

(Netgear Switch) (Config)#interface 1/0/2

(Netgear Switch) (Interface 1/0/2)#ip rip

(Netgear Switch) (Interface 1/0/2)#ip rip receive version both

(Netgear Switch) (Interface 1/0/2)#ip rip send version rip2

(Netgear Switch) (Interface 1/0/2)#exit

(Netgear Switch) (Config)#interface 1/0/3

(Netgear Switch) (Interface 1/0/3)#ip rip

(Netgear Switch) (Interface 1/0/3)#ip rip receive version both

(Netgear Switch) (Interface 1/0/3)#ip rip send version rip2

(Netgear Switch) (Interface 1/0/3)#exit

(Netgear Switch) (Config)#exit

Web Interface: Enable RIP for Ports 1/0/2 and 1/0/3

1. Select Routing > RIP > Advanced > RIP Configuration.

A screen similar to the following displays.

2. Enter the following information:

• In the Interface field, select 1/0/2.

• For RIP Admin Mode, select the Enable radio button.

• In the Send V

ersion field, select RIP-2.

3. Click Apply to save the settings.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 558 559

Comments to this Manuals

No comments

Netgear Switch M4100 User Manual Page 80

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100