Netgear 7300 Series User Manual Page 91
- Page / 364
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-25
202-10009-01_060204
Network Configuration Protocol Current Indicates which network protocol is being
used. The options are bootp | dhcp | none.
Java Mode Specifies if the switch should allow access to the Java applet in
the header frame. Enabled means the applet can be viewed. The
factory default is disabled.
Management VLAN ID
Specifies the management VLAN ID.
show remotecon
This command displays telnet settings.
Format
show remotecon
Mode
Privileged EXEC and User EXEC
Remote Connection Login Timeout (minutes) This object indicates the number of
minutes a remote connection session is allowed to remain inac-
tive before being logged off.A zero means there will be no time-
out. May be specified as a number from 0 to 160. The factory
default is 5.
Maximum Number of Remote Connection Sessions This object indicates the num-
ber of simultaneous remote connection sessions allowed. The fac-
tory default is 5.
Allow New Telnet Sessions Indicates that new telnet sessions will not be allowed when
set to no. The factory default value is yes.
show serial
This command displays serial communication settings for the switch.
Format
show serial
Mode Privileged EXEC and User EXEC
Serial Port Login Timeout (minutes) Specifies the time, in minutes, of inactivity on a
Serial port connection, after which the Switch will close the con-
nection. Any numeric value between 0 and 160 is allowed, the
factory default is 5. A value of 0 disables the timeout.
Baud Rate The default baud rate at which the serial port will try to connect.
The available values are 1200, 2400, 4800, 9600, 19200,
- User Manual for the 1
- NETGEAR 7300 Series Layer 1
- 3 Managed Switch Software 1
- Technical Support 2
- Trademarks 2
- Statement of Conditions 2
- Contents 5
- Chapter 1 27
- About This Guide 27
- Typographical Conventions 28
- Special Message Formats 28
- About This Guide 1-3 29
- How to Print this Manual 30
- Chapter 2 31
- Chapter 3 33
- Chapter 4 37
- Interactive Switch Image 41
- Main Menus 42
- Secondary Menus 43
- System-Wide Popup Menus 44
- Port-Specific Popup Menus 45
- Chapter 5 47
- Parameters 48
- Conventions 49
- Annotations 50
- Chapter 6 51
- Quick Start up 51
- System Info and System Setup 52
- Quick Start up IP Address 53
- 6-4 Quick Start up 54
- Quick Start up 6-5 55
- (Only XMODEM) 56
- Quick Start up 6-7 57
- 6-8 Quick Start up 58
- Chapter 7 59
- Mode-based CLI 59
- Mode-based Topology 61
- 7-4 Mode-based CLI 62
- FIGURE 1. Mode-based CLI 62
- Mode-based Command Hierarchy 63
- Flow of Operation 65
- “No” Form of a Command 66
- Chapter 8 67
- Switching Commands 67
- 8-2 Switching Commands 68
- Switching Commands 8-3 69
- 8-4 Switching Commands 70
- Switching Commands 8-5 71
- 8-6 Switching Commands 72
- Switching Commands 8-7 73
- 8-8 Switching Commands 74
- Switching Commands 8-9 75
- 8-10 Switching Commands 76
- Switching Commands 8-11 77
- 8-12 Switching Commands 78
- Switching Commands 8-13 79
- 8-14 Switching Commands 80
- Management VLAN Commands 81
- Dot1P Commands 82
- Switching Commands 8-17 83
- Management Commands 84
- Switching Commands 8-19 85
- 8-20 Switching Commands 86
- Switching Commands 8-21 87
- 8-22 Switching Commands 88
- Switching Commands 8-23 89
- 8-24 Switching Commands 90
- Switching Commands 8-25 91
- 8-26 Switching Commands 92
- Switching Commands 8-27 93
- 8-28 Switching Commands 94
- Switching Commands 8-29 95
- 8-30 Switching Commands 96
- Switching Commands 8-31 97
- 8-32 Switching Commands 98
- Switching Commands 8-33 99
- 8-34 Switching Commands 100
- 202-10009-01_060204 100
- HTTP Commands 101
- 8-36 Switching Commands 102
- Secure Shell (SSH) Commands 103
- Device Configuration Commands 104
- Switching Commands 8-39 105
- 8-40 Switching Commands 106
- Switching Commands 8-41 107
- 8-42 Switching Commands 108
- Switching Commands 8-43 109
- 8-44 Switching Commands 110
- Switching Commands 8-45 111
- 8-46 Switching Commands 112
- Switching Commands 8-47 113
- 8-48 Switching Commands 114
- Switching Commands 8-49 115
- 8-50 Switching Commands 116
- Switching Commands 8-51 117
- 8-52 Switching Commands 118
- Switching Commands 8-53 119
- 8-54 Switching Commands 120
- Switching Commands 8-55 121
- 8-56 Switching Commands 122
- Switching Commands 8-57 123
- 8-58 Switching Commands 124
- Switching Commands 8-59 125
- 8-60 Switching Commands 126
- Switching Commands 8-61 127
- 8-62 Switching Commands 128
- Switching Commands 8-63 129
- 8-64 Switching Commands 130
- Switching Commands 8-65 131
- 8-66 Switching Commands 132
- Switching Commands 8-67 133
- 8-68 Switching Commands 134
- Switching Commands 8-69 135
- 8-70 Switching Commands 136
- Switching Commands 8-71 137
- 8-72 Switching Commands 138
- Switching Commands 8-73 139
- 8-74 Switching Commands 140
- Switching Commands 8-75 141
- 8-76 Switching Commands 142
- Spanning Tree Commands 143
- 8-78 Switching Commands 144
- Switching Commands 8-79 145
- Enabled or disabled 145
- 8-80 Switching Commands 146
- Switching Commands 8-81 147
- 8-82 Switching Commands 148
- Switching Commands 8-83 149
- 8-84 Switching Commands 150
- Switching Commands 8-85 151
- 8-86 Switching Commands 152
- Switching Commands 8-87 153
- 8-88 Switching Commands 154
- Switching Commands 8-89 155
- 8-90 Switching Commands 156
- Switching Commands 8-91 157
- 8-92 Switching Commands 158
- Switching Commands 8-93 159
- 8-94 Switching Commands 160
- Security Commands 161
- 8-96 Switching Commands 162
- Switching Commands 8-97 163
- 8-98 Switching Commands 164
- Switching Commands 8-99 165
- 8-100 Switching Commands 166
- Switching Commands 8-101 167
- 8-102 Switching Commands 168
- Switching Commands 8-103 169
- 8-104 Switching Commands 170
- Switching Commands 8-105 171
- 8-106 Switching Commands 172
- Switching Commands 8-107 173
- 8-108 Switching Commands 174
- Switching Commands 8-109 175
- 8-110 Switching Commands 176
- Switching Commands 8-111 177
- System Utilities 178
- Switching Commands 8-113 179
- 8-114 Switching Commands 180
- Switching Commands 8-115 181
- 8-116 Switching Commands 182
- Chapter 9 183
- Routing Commands 183
- 9-2 Routing Commands 184
- Routing Commands 9-3 185
- 9-4 Routing Commands 186
- Routing Commands 9-5 187
- 9-6 Routing Commands 188
- Routing Commands 9-7 189
- 9-8 Routing Commands 190
- Routing Commands 9-9 191
- 9-10 Routing Commands 192
- Routing Commands 9-11 193
- 9-12 Routing Commands 194
- Routing Commands 9-13 195
- 9-14 Routing Commands 196
- Routing Commands 9-15 197
- 9-16 Routing Commands 198
- Routing Commands 9-17 199
- 9-18 Routing Commands 200
- Routing Commands 9-19 201
- 9-20 Routing Commands 202
- Routing Commands 9-21 203
- 9-22 Routing Commands 204
- Routing Commands 9-23 205
- 9-24 Routing Commands 206
- Routing Commands 9-25 207
- 9-26 Routing Commands 208
- Routing Commands 9-27 209
- 9-28 Routing Commands 210
- Routing Commands 9-29 211
- 9-30 Routing Commands 212
- Routing Commands 9-31 213
- 9-32 Routing Commands 214
- Routing Commands 9-33 215
- 9-34 Routing Commands 216
- Routing Commands 9-35 217
- 9-36 Routing Commands 218
- Routing Commands 9-37 219
- 9-38 Routing Commands 220
- Routing Commands 9-39 221
- 9-40 Routing Commands 222
- Routing Commands 9-41 223
- 9-42 Routing Commands 224
- Routing Commands 9-43 225
- 9-44 Routing Commands 226
- Routing Commands 9-45 227
- 9-46 Routing Commands 228
- Routing Commands 9-47 229
- 9-48 Routing Commands 230
- Routing Commands 9-49 231
- 9-50 Routing Commands 232
- Routing Commands 9-51 233
- 9-52 Routing Commands 234
- Routing Commands 9-53 235
- 9-54 Routing Commands 236
- Routing Commands 9-55 237
- 9-56 Routing Commands 238
- Routing Commands 9-57 239
- 9-58 Routing Commands 240
- Routing Commands 9-59 241
- 9-60 Routing Commands 242
- Chapter 10 243
- General Commands 244
- Class Commands 245
- Policy Commands 253
- Service Commands 257
- Show Commands 259
- Mode Privileged EXEC 261
- Chapter 11 269
- CLI Commands: ACL 269
- Configuration Commands 270
- CLI Commands: ACL 11-3 271
- 11-4 CLI Commands: ACL 272
- Chapter 12 273
- DHCP Server Commands 273
- 12-2 DHCP Server Commands 274
- DHCP Server Commands 12-3 275
- 12-4 DHCP Server Commands 276
- DHCP Server Commands 12-5 277
- DHCP Server Show Commands 278
- DHCP Server Commands 12-7 279
- 12-8 DHCP Server Commands 280
- DHCP Server Clear Commands 281
- 12-10 DHCP Server Commands 282
- Chapter 13 283
- Privilege 287
- Appendix A 289
- IS CLI Mapping 289
- A-2 IS CLI Mapping 290
- IS CLI Mapping A-3 291
- A-4 IS CLI Mapping 292
- IS CLI Mapping A-5 293
- A-6 IS CLI Mapping 294
- IS CLI Mapping A-7 295
- A-8 IS CLI Mapping 296
- IS CLI Mapping A-9 297
- A-10 IS CLI Mapping 298
- IS CLI Mapping A-11 299
- A-12 IS CLI Mapping 300
- IS CLI Mapping A-13 301
- A-14 IS CLI Mapping 302
- IS CLI Mapping A-15 303
- A-16 IS CLI Mapping 304
- IS CLI Mapping A-17 305
- A-18 IS CLI Mapping 306
- IS CLI Mapping A-19 307
- A-20 IS CLI Mapping 308
- IS CLI Mapping A-21 309
- A-22 IS CLI Mapping 310
- IS CLI Mapping A-23 311
- A-24 IS CLI Mapping 312
- IS CLI Mapping A-25 313
- A-26 IS CLI Mapping 314
- IS CLI Mapping A-27 315
- A-28 IS CLI Mapping 316
- IS CLI Mapping A-29 317
- A-30 IS CLI Mapping 318
- IS CLI Mapping A-31 319
- A-32 IS CLI Mapping 320
- IS CLI Mapping A-33 321
- A-34 IS CLI Mapping 322
- IS CLI Mapping A-35 323
- A-36 IS CLI Mapping 324
- IS CLI Mapping A-37 325
- A-38 IS CLI Mapping 326
- IS CLI Mapping A-39 327
- A-40 IS CLI Mapping 328
- IS CLI Mapping A-41 329
- A-42 IS CLI Mapping 330
- IS CLI Mapping A-43 331
- A-44 IS CLI Mapping 332
- IS CLI Mapping A-45 333
- A-46 IS CLI Mapping 334
- Appendix B 335
- Cabling Guidelines 335
- Category 5 Cable 336
- Twisted Pair Cables 337
- Patch Panels and Cables 338
- Cabling Guidelines B-5 339
- Near End Cross Talk (NEXT) 340
- Patch Cables 340
- Cabling Guidelines B-7 341
- Conclusion 342
- Appendix C 343
- Glossary 343
- Diffserv 348
- Domain Name 348
- IP Multicasting 352
- Internet Protocol 352
- SimpleX signaling 360
Related products and manuals for Computer Accessories Netgear 7300 Series
(2 pages)
(15 pages)© 2020, manymanuals.com. All rights reserved. | 2.033 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals