Netgear 7300 Series User Manual Page 151

  • Download
  • Add to my manuals
  • Print
  • Page
    / 364
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 150
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-85
202-10009-01_060204
no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format no spanning-tree edgeport
Mode Interface Config
spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value. The Force Protocol
Version can be one of the following:
802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality
supported)
802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality
supported)
802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Default 802.1s
Format spanning-tree forceversion <802.1d | 802.1w | 802.1s>
Mode Global Config
no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value, i.e. 802.1s.
Format no spanning-tree forceversion
Mode Global Config
spanning-tree forward-time
This command sets the Bridge Forward Delay parameter to a new value for the common and
internal spanning tree. The forward-time value is in seconds within a range of 4 to 30, with the
value being greater than or equal to "(Bridge Max Age / 2) + 1".
Default 15
Format spanning-tree forward-time <4-30>
Mode Global Config
Page view 150
1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 363 364

Comments to this Manuals

No comments