Netgear 7300 Series User Manual download pdf (Page 346)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

C-4 Glossary

202-10009-01_060204

Bootstrap Protocol

An Internet protocol that enables a diskless workstation to discover its own IP address, the IP address of a

BootP server on the network, and a file to be loaded into memory to boot the machine. This enables the

workstation to boot without requiring a hard or floppy disk drive.

Bridge Protocol Data Unit

BPDU is the IEEE 802.1D MAC Bridge Management protocol that is the standard implementation of STP

(Spanning Tree Protocol). It uses the STP algorithm to insure that physical loops in the network topology do

not result in logical looping of network traffic. Using one bridge configured as root for reference, the BPDU

switches one of two bridges forming a network loop into standby mode, so that only one side of a potential

loop passes traffic. By examining frequent 802.1d configuration updates, a bridge in the standby mode can

switch automatically into the forward mode if the other bridge forming the loop fails.

Broadcast

A packet sent to all devices on a network.

Broadcast storm

Multiple simultaneous broadcasts that typically absorb all the available network bandwidth and can cause a

network to fail. Broadcast storms can be due to faulty network devices or network loops.

Cat 5

Category 5 unshielded twisted pair (UTP) cabling. An Ethernet network operating at 10 Mbits/second

(10BASE-T) will often tolerate low quality cables, but at 100 Mbits/second (10BASE-Tx) the cable must be

rated as Category 5, or Cat 5 or Cat V, by the Electronic Industry Association (EIA).

This rating will be printed on the cable jacket. Cat 5 cable contains eight conductors, arranged in four

twisted pairs, and terminated with an RJ45 type connector. In addition, there are restrictions on maximum

cable length for both 10 and 100 Mbits/second networks.

Capacity planning

Determining whether current solutions can satisfy future demands. Capacity planning includes evaluating

potential workload and infrastructure changes.

Checksum

A simple error-detection scheme in which each transmitted message is identified with a numerical value

based on the number of set bits in the message. The receiving station then applies a formula to the message

and checks to make sure the accompanying numerical value is the same. If not, the receiver can assume that

the message has been corrupted.

1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 363 364

No comments

Netgear 7300 Series User Manual Page 346