Netgear 7300 Series User Manual download pdf (Page 169)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

Switching Commands 8-103

202-10009-01_060204

radius server key

This command is used to configure the shared secret between the RADIUS client and the RADIUS

accounting / authentication server. Depending on whether the 'auth' or 'acct' token is used, the

shared secret will be configured for the RADIUS authentication or RADIUS accounting server.

The IP address provided must match a previously configured server. When this command is

executed, the secret will be prompted. The secret must be an alphanumeric value not exceeding 20

characters.

Format radius server key {auth | acct} <ipaddr>

Mode Global Config

radius server msgauth

This command enables the message authenticator attribute for a specifiedserver.

Default

radius server msgauth <ipaddr>

Mode Global Config

radius server primary

This command is used to configure the primary RADIUS authentication server for this RADIUS

client. The primary server is the one that is used by default for handling RADIUS requests. The

remaining configured servers are only used if the primary server cannot be reached. A maximum

of three servers can be configured on each client. Only one of these servers can be configured as

the primary. If a primary server is already configured prior to this command being executed, the

server specified by the IP address specified used in this command will become the new primary

server. The IP address must match that of a previously configured RADIUS authentication server.

Format radius server primary <ipaddr>

Mode Global Config

radius server retransmit

This command sets the maximum number of times a request packet is re-transmitted when no

response is received from the RADIUS server. The retries value is an integer in the range of 1 to

15.

Default 10

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 363 364

No comments

Netgear 7300 Series User Manual Page 169