Netgear GS728TPP User Manual download pdf (Page 75)

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches

You can select multiple ports and LAGs to apply the same setting to the selected

interfaces. Select the check box in the heading row to apply the same settings to all

interfaces.

4. Configure or view the settings:

• Description. Enter the description string to be attached to a port. The string can be

up to 64 characters in length.

• Port Type. This field is blank for most ports. Otherwise, the possible values are:

• Mirrored. Indicates that the port is a source mirroring port.

• Probe. Indicates that the port is a destination mirroring port.

• LAG. Indicates that the port is a member of a link aggregation trunk. For more

information, see

Link Aggregation Groups .

• Admin Mode. Select the menu the port control administration state, which can be

one of the following:

• Enable. The port can participate in the network (default).

• Disable. The port is administratively down and does not participate in the network.

• Port Speed. Select the port’s speed and duplex mode. If you select Auto, the

autonegotiation process sets the duplex mode and speed. The port’s maximum

capability (full duplex and 1000 Mbps) is advertised. Otherwise, your selection

determines the port’s duplex mode and transmission rate. The factory default is Auto.

• Physical Status. Indicates the physical port’s speed and duplex mode.

• Link Status. Indicates whether the link is up or down.

• MAC Address. Displays the physical address of the specified interface.

• ifIndex. The ifIndex of the interface table entry associated with this port. If the

interface field is set to All, this field is blank.

5. Click APPLY to apply the changes to the system.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 276 277

No comments

Netgear GS728TPP User Manual Page 75