201
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
alternative ways of specifying a match criterion for the same Service Type field in the
IP header; however, each uses a different user notation. After you select the service
type, specify the value associated with the type.
• IP DSCP: Specify the IP Dif
fServ Code Point (DSCP) value. The DSCP is defined
as the high-order 6 bits of the service type octet in the IP header. Select an IP
DSCP value from the list. To specify a numeric value in the available field, select
Other from the list and type an integer from 0 to 63 in the field.
4. Click ADD.
To modify an existing IP Extended ACL rule, click in the Rule ID field. The number is a
hyperlink to the Extended
ACL Rule Configuration screen.
If you modify the rule, click APPL
Y to submit the changes to the switch.
IPv6 ACL
An IPv6 ACL consists of a set of rules that are matched sequentially against a packet. When
a packet meets the match criteria of a rule, the specified rule action (permit or deny) is taken,
and the additional rules are not checked for a match. On this screen, the interfaces to which
an IP ACL applies must be specified, as well as whether it applies to inbound or outbound
traffic.
To add an IPv6 ACL:
1. Select Security
ACL, then click the Advanced IPv6 ACL link.
The following screen displays:
2. In the IPv6 ACL field, configure the name of IPv6 ACL.
• The number of the rules associated with the IP
ACL is displayed in the Rules field.
• The
ACL type is IPv6 ACL and is displayed in the Type field.
Comments to this Manuals