Netgear GS728TPP User Manual download pdf (Page 130)

130

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches

Configure and View Routes

From the Routing Table screen, you can configure static and default routes and view the

routes that the NETGEAR switch has already learned.

 To configure routes:

1. Select Routing  Routing T

able.

The following screen displays:

2. In the Route

Type field, specify whether the route is to be a default route or a static route.

When you create a default route, all you need to specify is the next hop IP address.

3. In the Network

Address field, specify the IP route prefix for the destination.

To create a route, a valid routing interface must exist and the next hop IP Address must

be on the same network as the routing interface.

4. In the Subnet Mask field, indicate the portion of the IP address that identifies the attached

network.

5. In the Next Hop IP

Address field, specify The outgoing router IP address to use when

forwarding traffic to the next router (if any) in the path towards the destination.

The next router is always one of the adjacent neighbors or the IP address of the local

interface for a directly attached network.

When you create a route, the next hop IP must be on the same network as the routing

interface. V

alid next hop IP addresses can be seen on the Route Table screen.

6. In the Preference field, specify a preference value for the configured next hop.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 276 277

No comments

Netgear GS728TPP User Manual Page 130