241
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
To configure the Traceroute settings and send probe packets to discover the route to
a host on the network:
1. Select Maintenance Troubleshooting Traceroute.
The following screen displays:
2. In the IP Address/Hostname field, specify the IP address or the host name of the station you
want the switch to ping.
The initial value is blank. This information is not retained across a power cycle.
3. Optionally
, configure the following settings:
• Probes Per Hop. Specify the number of times each hop must be probed.
The valid
range is 1–10.
• MaxTTL. Specify the maximum time-to-live for a packet in number of hops.
The valid
range is 1–255.
• InitTTL. Specify the initial time-to-live for a packet in number of hops.
The valid range
is 1–255.
• MaxFail. Specify the maximum number of failures allowed in the session.
The valid
range is 0–255.
• Interval. Specify the time between probes in seconds.
The valid range is 1–60.
• Port. Specify the UDP destination port in probe packets.
The valid range is 1–65535.
• Size. Specify the size of probe packets.
The valid range is 64–1472.
4. Click APPL
Y to initiate the traceroute. The results display in the Results field.
Comments to this Manuals