Netgear GS752TXS Technical Information download pdf (Page 62)

62 | Chapter 2: Configuring System Information

GS752TXS Smart Switch Software Administration Manual

Trap Flags

The pages in the Trap Manager folder allow you to view and configure information about

SNMP traps the system generates.

Use the Trap Flags page to enable or disable traps the switch can send to an SNMP

manager. When the condition identified by an active trap is encountered by the switch, a trap

message is sent to any enabled SNMP Trap Receivers, and a message is written to the trap

log.

To access the Trap Flags page, click System

 SNMP  SNMP V1/V2  Trap Flags.

To configure the trap flags:

1. From the Authentication field, enable or disable activation of authentication failure

traps by selecting the corresponding button. The factory default is Enable.

2. From the Link Up/Down field, enable or disable activation of link status traps by selecting

the corresponding button. The factory default is Enable.

3. From the Spanning Tree field, enable or disable activation of spanning tree traps by

selecting the corresponding button. The factory default is Enable.

4. If you make any changes to this page, click Apply to send the updated configuration to the

switch. Configuration changes take effect immediately.

5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to

the latest value of the switch.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 317 318

No comments

Netgear GS752TXS Technical Information Page 62