Chapter 4: Configuring Switching Information | 125
GS752TXS Smart Switch Software Administration Manual
To configure Auto-Video:
1. Globally enable or disable the Auto-Video administrative mode for the switch by
selecting the Auto-Video Status radio button.
The Auto-Video VLAN field show the number of Auto-configured IGMP snooping
VLANs.
2. Click Cancel to cancel the configuration on the screen and resets the data on the screen to
the latest value of the switch.
3. Click Apply t
o send the updated configuration to the switch. Configuration changes take
effect immediately.
IGMP Snooping
Internet Group Management Protocol (IGMP) Snooping is a feature that allows a switch to
forward multicast traffic intelligently on the switch. Multicast IP traffic is traffic that is destined
to a host group. Host groups are identified by class D IP addresses, which range from
224.0.0.0 to 239.255.255.255. Based on the IGMP query and report messages, the switch
forwards traffic only to the ports that request the multicast traffic. This prevents the switch
from broadcasting the traffic to all ports and possibly affecting network performance.
A traditional Ethernet network may be separated into different network segments to prevent
placing too many devices onto the same shared media. Bridges and switches connect these
segments. When a packet with a broadcast or multicast destination address is received, the
switch will forward a copy into each of the remaining network segments in accordance with
the IEEE MAC Bridge standard. Eventually, the packet is made accessible to all nodes
connected to the network.
This approach works well for broadcast packets that are intended to be seen or processed by
all connected nodes. In the case of multicast packets, however, this approach could lead to
less efficient use of network bandwidth, particularly when the packet is intended for only a
small number of nodes. Packets will be flooded into network segments where no node has
any interest in receiving the packet. While nodes will rarely incur any processing overhead to
Comments to this Manuals