Netgear GS752TXS Technical Information download pdf (Page 37)

Chapter 2: Configuring System Information | 37

GS752TXS Smart Switch Software Administration Manual

IP Configuration

Use the IP Configuration page to configure network information for the management

interface, which is the logical interface used for in-band connectivity with the switch through

any of the switch's front-panel ports. The configuration parameters associated with the

switch's network interface do not affect the configuration of the front panel ports through

which traffic is switched or routed.

To access the page, click System

 Management  IP Configuration. A screen similar to the

following displays.

To configure the network information for the management interface:

1. Select the appropriate radio button to determine how to configure the network

information for the switch management interface:

• Dynamic IP Address (DHCP). Specifies that the switch must obtain the IP address

through a DHCP server.

• Dynamic IP Address (BOOTP). Specifies that the switch must obtain the IP address

through a BootP server.

• Static IP Address. Specifies that the IP address, subnet mask, and default gateway

must be manually configured. Enter this information in the fields below this radio

button.

2. If you selected the Static IP Address option, configure the following network information:

• IP Address. The IP address of the network interface. The factory default value is

192.168.0.239. Each part of the IP address must start with a number other than zero.

For example, IP addresses 001.100.192.6 and 192.001.10.3 are not valid.

• Subnet Mask. The IP subnet mask for the interface. The factory default value is

255.255.255.0.

• Default Gateway. The default gateway for the IP interface. The factory default value

is 192.168.0.254.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 317 318

No comments

Netgear GS752TXS Technical Information Page 37