Netgear GS752TXS Technical Information download pdf (Page 285)

Chapter 9: Maintenance | 285

GS752TXS Smart Switch Software Administration Manual

1. In the Ping field, select either Global or Link Global to select either the global IPv6

Address/Hostname or Link Local Address to ping.

2. Optionally, configure the following settings:

• In the IPv6 Address/Host Name field, enter the IPv6 address or Hostname of the

station you want the switch to ping. The initial value is blank. The IPv6 Address or

Hostname you enter is not retained across a power cycle.

• In the Datagram Size. Enter the datagram size. The valid range is 48–2048.

• The Result field displays the result after the switch send a Ping IPv6 request to the

specified IPv6 address.

3. Click Cancel to cancel the operation on the screen and reset the data on the screen to the

latest value of the switch.

4. Click Apply to send the ping. The switch sends the number of pings specified in the Count

field, and the results are displayed below the configurable data in the Result area.

• If successful, the output will be Send count=3, Receive count = n from (IPv6

Address).Average round trip time = n ms.

• If a reply to the ping is not received, the following displays: “Reply From IP/Host:

Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec”.

Traceroute

Use the Traceroute utility to discover the paths that a packet takes to a remote destination.

To display this page, click Maintenance

 Troubleshooting  Traceroute.

To configure the Traceroute settings and send probe packets to discover the route to a host

on the network:

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 317 318

No comments

Netgear GS752TXS Technical Information Page 285